(888) 633-7804
Home / Locations / Argyle, MI / Whole House Rewiring

House Rewiring and Knob and Tube Replacement in Argyle

If your Argyle home still runs on its original wiring, a home rewiring project is the single biggest safety improvement you can make. We plan house rewiring so that most cable is fished through existing cavities, keeping plaster and drywall repair to a minimum.

Serving Argyle, Sanilac County and Snover, Decker and Ubly. Answered 24/7.

Whole house rewiring in Argyle: local conditions matter

Around Argyle, many homes are older farmhouses and village houses that have been updated in stages. It is common to find a modern panel feeding some very old wiring. For whole house rewiring in Sanilac County, our electricians sort out what can stay and what should be replaced.

Knob and tube and aluminum wiring in Michigan homes

Knob and tube wiring was standard until about the 1940s. It has no ground wire, its insulation becomes brittle with age, and it was never designed to be buried in attic insulation. Aluminum branch wiring, used in many homes built from the mid-1960s to the mid-1970s, expands and contracts more than copper and can loosen at connections. Both can make a home harder to insure and sell. A rewire in Argyle removes that worry and gives you grounded outlets and enough circuits for modern life.

What you get when you book whole house rewiring in Argyle, MI

Wiring assessment
We map existing circuits and identify knob and tube, aluminum and ungrounded cable.
Knob and tube wiring replacement
Old open wiring abandoned and replaced with modern grounded cable.
Aluminum wiring replacement or remediation
Full replacement, or approved connector repairs where that is the better fit.
New grounded outlets
Three-prong, tamper-resistant receptacles with GFCI and AFCI protection where required.
New panel and circuits
Enough circuits to separate kitchens, baths, laundry and bedrooms properly.
Careful access
Attic, basement and closet routes used first, with small, neat access holes when needed.

Signs you need whole house rewiring in Argyle

  • Two-prong outlets throughout the house
  • Cloth-covered or knob and tube wiring visible in the attic or basement
  • Aluminum branch wiring from the 1960s or 1970s
  • Frequent blown fuses or tripped breakers
  • An insurer or home inspector has flagged the wiring
  • Scorched outlets or a persistent burning smell

Smell burning, see sparks or have no power? Go straight to our emergency electrician in Argyle page or call (888) 633-7804.

Pricing for whole house rewiring in Argyle

Whole house rewiring cost in Argyle depends on the size of the home, the number of stories, wall and ceiling construction, how accessible the attic and basement are, and whether the panel and service are replaced at the same time. Plaster-and-lath houses take more care than open-framed ones. After walking the home we provide a written price, and the work can be phased by floor or by room.

Call (888) 633-7804 for a quote

Whole House Rewiring in Argyle: our process

  1. Get in touchCall (888) 633-7804 any time. We ask a few questions so the electrician arrives with the right parts.
  2. On-site assessmentWe look at the panel, the wiring and the work area, then give you a clear written price.
  3. Installation or repairWork is carried out safely and neatly, following the Michigan Electrical Code.
  4. Final checksWe test under load, label the panel, clean up and answer your questions.

Serving Argyle, Sanilac County and nearby towns

Our whole house rewiring service covers all of Argyle and the surrounding parts of Sanilac County. We cover ZIP code 48410. We also serve Snover, Decker and Ubly.

Questions about whole house rewiring in Argyle

How much does whole house rewiring cost in Argyle?

Each home is different. Square footage, access and the number of circuits and devices set the price. We provide a detailed written quote after an on-site assessment in Argyle.

Can I live in the house during a rewire?

Usually yes. We work in sections and restore power to the areas you need at the end of each day.

How long does it take to rewire a house?

A typical single-family home takes about one to two weeks depending on size and access.

Do you have to remove all the knob and tube wiring?

It must be disconnected and replaced. Sections that are inaccessible are abandoned in place and are no longer energized.

Will rewiring help with home insurance?

Many insurers ask about knob and tube and aluminum wiring. Replacing it removes a common obstacle. Check the details with your own agent.

Need whole house rewiring in Argyle? Talk to an electrician now.

Call (888) 633-7804
Call (888) 633-7804