LED Recessed Lighting Installation in Ralph

Recessed Lighting Installation for Ralph homes and businesses

Distances are long in the U.P. and so are the winters. Power here comes from utilities such as UPPCO, UMERC, Cloverland Electric and municipal systems like the Marquette Board of Light and Power, each with its own service requirements. Whoever supplies your address in Ralph, we plan recessed lighting installation in Dickinson County so that the job is done properly in a single trip wherever possible.

Getting recessed lighting right

The difference between a good recessed lighting job and a poor one is layout. Too few lights leave scallops and shadows. Too many make a ceiling look like an airport runway. As a starting point we space fixtures at about half the ceiling height, then adjust for cabinets, beams and seating. In Ralph homes with attics above, we use airtight fixtures so heated air is not lost through the ceiling in winter.

Recessed Lighting Installation services we provide in Ralph

Layout planning

Spacing worked out from ceiling height and room use so there are no dark spots or glare.

Slim LED wafer lights

Low-profile fixtures that fit under joists and ductwork.

Insulation-contact fixtures

IC and airtight rated lights for ceilings below attics.

Dimmers and zones

Separate switching for work areas and seating areas.

Color temperature selection

Warm, neutral or selectable-white fixtures to suit the room.

Retrofit trims

Old cans converted to LED without new holes.