LED Recessed Lighting Installation in Barbeau

Recessed Lighting Installation for Barbeau homes and businesses

Electrical systems in the Upper Peninsula work harder than most. In Barbeau and across Chippewa County, long heating seasons mean furnaces, boilers, heat tape and block heaters run for months, and storms off the Great Lakes can take power down without warning. When we carry out recessed lighting installation here, we size and protect every circuit with those demands in mind.

Getting recessed lighting right

The difference between a good recessed lighting job and a poor one is layout. Too few lights leave scallops and shadows. Too many make a ceiling look like an airport runway. As a starting point we space fixtures at about half the ceiling height, then adjust for cabinets, beams and seating. In Barbeau homes with attics above, we use airtight fixtures so heated air is not lost through the ceiling in winter.

What our recessed lighting installation service in Barbeau includes

Layout planning

Spacing worked out from ceiling height and room use so there are no dark spots or glare.

Slim LED wafer lights

Low-profile fixtures that fit under joists and ductwork.

Insulation-contact fixtures

IC and airtight rated lights for ceilings below attics.

Dimmers and zones

Separate switching for work areas and seating areas.

Color temperature selection

Warm, neutral or selectable-white fixtures to suit the room.

Retrofit trims

Old cans converted to LED without new holes.